Controlador de atenuación LED de 12V DC para tiras de led RGB Silamp 30m de control remoto

This controller can control at a distance of up to 30mt strips RGB 12v, thanks to its technology, RF, dto use paired with the remote control (sold separately), you can make games of light and change the color of your strip.

The controller has a maximum load of 100w, running at 12v dc so you will need match with a transformer suitable. For each of the commands: on, off, color change, change in light or color variation it is necessary to wait a maximum time of 5 seconds from when the button is pressed.

MODE OF RECOVERY (from the remote):

Click on TO OFF for 3 seconds, otherwise click ON for a few seconds until the strip not to blink for 10 times.

More information on the remote control: : https://www.silamp.it/telecomando-per-controller-rgb-dimmer-led-silamp-30mt-controllo-remoto-p-23898.html

INSTALL THE LINKS:

Check that the unit is not present exterior damages . Pay attention to the anode and at the cathode as it may not be connected to the contrary.

The entrance (input) of the controller must be connected to a power supply at 12v DC,it is NOT possible to connect it directly to 220v, otherwise the ??controller will be damaged or burn.

There are two possibilities, or via the connector jack of the transformer, or if your transformer has an output with two wires, connect the POSITIVE with POSITIVE (plus sign +), and NEGATIVE with the NEGATIVE (minus sign - ).

The output of the controller connects to the strip, RGB LED 12V:

• B (blue): wire color BLUE - strip LED RGB 12V
• G (green): wire color GREEN strip LED RGB 12V
• R (red): wire color RED strip LED RGB 12V
• + : wire to the POSITIVE + (plus sign) of the strip LED RGB 12V

See details in the following image.

SPECIFICATIONS

Contenido del paquete:

Ø 1 Controlador de LED de 12V